Questions? Call us+234 814 020 5895
EV chargers draw sustained, high loads that most existing panels weren’t designed for. We assess available capacity, upgrade supply where needed, and install a dedicated, correctly protected circuit, with load management where solar or generator integration is in play.
Capacity assessment
Existing panel capacity checked against the charger’s real draw, with upgrades identified if needed.
Circuit design
A dedicated, correctly protected circuit designed for the charger and its actual location.
Installation
Circuit run and charger mounted and wired to spec.
Commissioning
System tested and, where relevant, load-managed against solar or generator supply before handover.
For ev charger installation, depending on the project and the agreed scope. We provide documentation appropriate to the size and complexity of the job.
All engineering deliverables →Connected loads, estimated demand, circuit schedules, distribution requirements, and existing versus proposed loads, giving a clearer basis for design and upgrade decisions.
Distribution board schedules, circuit identification, cable information, equipment schedules, and installation photographs.
Test results recorded before handover, plus as-built information and solar/backup handover information where produced.
Both. We supply solar panels, batteries and inverters, and we do the installation and commissioning ourselves. We still run a load assessment before recommending or supplying equipment, because the right panel count and battery capacity depend on your actual consumption.
It depends on the property's size, current wiring condition, and how many circuits, sockets, and fixtures are involved. Rewiring a two-bedroom flat and a multi-storey house aren't comparable jobs. We don't quote a number without a site visit, since guessing risks under- or over-pricing the actual scope. Request a quote and we'll assess the property directly.
Hybrid inverter and battery system pricing depends on inverter capacity, battery chemistry and bank size, and whether it's a backup-only setup or one designed to carry most of your daily load (see our guide on sizing a hybrid inverter system for why that distinction matters). We size and quote from a real load assessment.
It scales with scope. A few automated lighting circuits costs far less than whole-property lighting, climate, and access control on one platform. Retrofitting an existing property also typically costs more than wiring automation into a new build from the start. We scope and quote after understanding what you actually want to control.
Describe the job in a few lines. We'll come back with a proper scope for it.
