The tools behind every site visit
Every Kell Electricals engagement — a quote, a booked site assessment, an emergency callout — runs through the same four capabilities on site, and ends in a documented report, not a verbal opinion.
RC 1852579 · COREN · NEMSA CERTIFIED
Load audits
Circuit-level consumption measured on site, not estimated — the same audit that seeds every sizing recommendation that follows it.
Cable & protection sizing
Every cable run and protective device sized to the measured load and logged against the job’s own single-line diagram, not a rule of thumb.
Solar & generator sizing
Panel, battery, inverter, and generator capacity sized from real consumption data and backup priorities — the grid you actually have, not a generic panel count.
Standards-referenced inspections
Findings checked against COREN/NEMSA-referenced checklists on site, with photo evidence attached to each finding — not a verbal walk-through.
Every visit ends in a report, not an opinion
Findings, sizing calculations, and photo evidence from each of the four tools above are compiled into a single documented report and handover certificate before the job is closed — the same standard whether the visit was a load audit alone or a complete site assessment.
- Site & client intake, logged against a persistent client record
- Load audit and, where relevant, an electrical plan
- Cable & protection sizing or solar/generator sizing, as scoped
- Standards-referenced inspection with photo evidence
- Commissioning notes and a handover report on close