Site safety, written down and followed
Electrical work is dangerous, for our team and for everyone around the site. This is how we run safety on every job.
How our team actually works
PPE is mandatory on site
Hard hats, safety glasses, insulated gloves rated for the work being done, and appropriate footwear are standard on every site, for every technician, on every visit - not reserved for jobs that look risky.
Isolation before investigation
A circuit is isolated and verified dead with a proper tester before it's opened up or worked on - never assumed safe from a breaker position or a label. This applies whether the job is a routine repair or a fault diagnosis.
Hazard-specific procedure for live and confined work
Work that genuinely requires a live circuit (fault-finding under load, for example) follows its own safe method of work, stricter than the general caution used on de-energized jobs. Confined spaces and elevated work get their own access and rescue planning before work starts.
Site handover briefing
On a multi-trade site, our team briefs on the specific hazards of that day's work before starting - what's isolated, what's live, and what other trades need to know is happening nearby.
How safety gets recorded
COREN-registered engineers, NEMSA-compliant, with documentation to match
Safety practice and regulatory compliance run together on our jobs - see what certification means in practice and the documentation handed over on every job.
Certifications & Compliance
Need a contractor with a documented HSE process?
Tell us about your site's requirements and we'll scope the work with your safety expectations built in.