Solar & Hybrid Energy Systems
In Nigeria, reliable power means designing for the grid you actually have. So before we specify a single panel, we run a full load analysis. Then we size the system to what you really use.
We measure first
Most oversized or undersized solar installs trace back to one thing: sizing from an assumption instead of a measurement. Our process starts with data.
A solar system can look good on paper and still disappoint you if it was not designed around how you actually use electricity. That is why we pay attention to the load before we recommend a system.
Consumption audit
We measure circuit-level consumption over time to build a real load profile: peak demand, and what actually runs during an outage. Your utility bill can’t tell us that.
System sizing
Panel array, battery bank, and inverter capacity are sized against the measured load and your backup priorities, with headroom for things you’ll add later. A system shouldn’t be maxed out on day one.
Component selection
Hybrid inverter and battery chemistry selected for your duty cycle. Daily cycling for backup-only systems is a different spec than a system designed to reduce generator hours materially.
Installation & integration
Grid, solar, and generator integrated with automatic transfer, installed to the documented design with safety isolation observed throughout.
Commissioning & handover
Performance testing against the design spec, monitoring setup, and documented handover, so you know the system is delivering what it was sized to deliver.
Sized to what the system actually needs to do
These are starting points for the conversation, not fixed packages. Your exact panel count, battery capacity, and inverter rating come out of the consumption audit above.
Backup essentials
Keeps critical circuits running through an outage: lighting, networking, security systems, refrigeration.
Best fit
Homes and small offices prioritizing outage continuity over full independence from the grid.
Full home or office
Sized to carry the majority of daily consumption, including air conditioning and larger appliance loads, with the grid or generator as backup rather than the primary source.
Best fit
Households and businesses that want to rely much less on the grid and the generator.
Commercial & industrial
Three-phase hybrid systems integrated with existing generator infrastructure and load management, sized against measured industrial or commercial demand profiles.
Best fit
Businesses where generator fuel cost or downtime risk justifies a larger, professionally load-managed system.
What the sizing process looks like in practice
Worked in general terms to show the logic. Your actual numbers come from your own consumption audit, not this example.
Measure
Circuit-level monitoring identifies which loads run during a typical outage and for how long. This becomes the backup load profile.
Size
Battery capacity is sized to that backup load profile plus a safety margin; panel array is sized to recharge that capacity within the available daylight hours.
Verify
Commissioning tests confirm the system carries the backup load for as long as it was designed to. Switching on isn’t the test.
Scope a job with our team
Tell us what you need built, fixed or installed. We’ll look at it properly and come back with a scoped assessment.